Rogers Door Lock Battery Replacement

4 smart home monitoring battery replacement instructions 1.

Rogers door lock battery replacement.

This is the only way to get a battery from them. Manufacturer s installation guide important installation steps 1. Press locking mechanism using a flathead screwdriver until sensor pops off its base. An allen wrench is provided in the original door lock box 2.

Yes i understand that but for rogers to replace the batteries they need to send it into the repair facility so they can change the batteries for you. Remove the existing door lock. The lock has been reset when the led flashes green. Test the lock and unlock functionality of the door lock s keypad.

The stores have no way and are not allowed to change the batteries for you as they only have batteries to sell not to give out for warranty issues. Pair the smart door lock to your rogers smart home monitoring system using. Tap on the door lock icon to be unpaired. Physical reset weiser lock.

If the keypad doesn t light up open the battery pack and replace the batteries with fresh alkaline ones. The front panel led comes on 6. While pressing and holding the tamper switch insert the battery into the sensor with the positive end oriented towards the tamper switch. Make sure the batteries are working by pressing the lock button on the door lock s keypad.

Find locking mechanism tab on the narrow side of sensor with led light pointing toward it. The led blinks green 7. Install 4 aa batteries in battery pack. Remove the battery pack from the interior assembly.

If the batteries are fine the keypad will light up. Select yes to un pair. Remove the battery pack. Replace sensor by sliding the locking tab back into place.

4 smart home monitoring battery replacement instructions 1. Press the program button again. Replace the sensor back plate as shown on the left. Press and hold the program button while reinserting the battery pack.

Confirm door lock delete screen will appear. Remove the battery cover. Remove and replace battery. Use the ball tip of an allen wrench to remove the three screws holding the cover.

Hold the program button for 30 seconds until the status led flashes red. After 1 second release the tamper switch.